Instructions for Oyster Mushroom Grow Kit

from the Coralville Public Library class on 21Nov2026, courtesy of Todd

Kit contents:

  • 1 plastic mushroom colonization bag with ventilation port

  • 1 2oz misting bottle

  • enough straw to fill the bag

  • 1 bag of oyster mushroom grain spawn

  • 2 zip ties

Materials/ Equipment needed:

  • A large pot for boiling 2 - 3 gallons of water

  • A 2 or 5 gallon bucket with a lid (or similar) large enough to contain straw and 2-3 gallons of water during pasteurization

  • A large cooler/ box large enough to fit 2-5 gallon bucket/ container

  • A few towels and/ or blankets to wrap (insulate) bucket during pasteurization

  • A large colander/ screen for draining straw after pasteurization (a screen type colander is best)

  • A piece of plastic sheeting for a fruiting area

  • Rubbing alcohol

Instructions

Step 1: Pasteurize the straw

  • Place straw in a container with lid (1-5 gallon bucket / cooking pot) large enough to cover straw with a few inches of water

  • Bring 2-3 gallons water to 190 degrees or to a boil and let stand for 5-10 minutes

  • Pour hot water over straw and cover (be careful, it’s hot!)

  • Place straw/ hot water container in a cooler or box with a towel on the bottom

  • Wrap and cover with towels/ blankets to retain heat

  • Allow to steep (pasteurize) 6-10 hours

  • When pasteurization time is up, drain with a colander or window screen. Allow to drip until straw is moist but no longer dripping

  • Allow to cool to room temperature, loosely covered to minimize airborne contamination. Grain spawn will not tolerate hot or even warm temps

Step 2: Assemble the fruiting bag

  • On a clean countertop or similar surface, clean hands and lower arms (roll up sleeves or short sleeves) with soap and water. Wipe down surface and hands with rubbing alcohol. The purpose is to minimize potential contaminants (A facemask would be good too)

  • Place straw and grain spawn bag on the working area

  • Place bag on countertop and open

  • Assemble fruiting bag using lasagna method. Start with 2 inches of straw, then 1 teaspoon (roughly) of grain spawn and repeat with a light layer of straw last. Ensure that the straw/ spawn is at least 2-3” below the filter patch

  • Use clean hand to gently tamp the straw down into the bag to lightly yet firmly compact. This is to remove a bit of air and provide more straw to spawn contact

  • Carefully close and twist top of bag and use zip tie to seal well (1-2 inches from the top of the bag and without blocking the filter patch)

Step 3: The wait

  • Place bag in a dark, 60-70 degree cupboard or similar area with a bit of room to breathe (through the filter patch) Try to keep dark and check once a day to minimize light exposure

  • Now the 1st waiting session. In a few days to a week or so, you should see the mycelium starting to grow and colonizing the fruiting bag. It will look like white wispy patches. The waiting should be 10-20 days until the bag is mostly colonized (white) but the straw is still visible

  • If, after a few days on, if other colors appear (green, pink, orange or appears slimy/watery with little or no white), it is contaminated and therefore ruined. It happens but straw, clean careful assembly, and aggressive mycelium make this method fairly contaminate averse. It still is useful for compost if contaminated

Step 4: Fruiting time

  • Once the bag is colonized (1 to 3 weeks) remove from colonization area. The bag should be consistently white in most areas. The straw will still be a bit visible but surrounded by the white mycelium

  • Carefully wipe a sharp knife (X-acto or razor blade or scalpel) or scissors with rubbing alcohol to sterilize

  • Cut 2 - 3, 2 inch X marks around the center of the bag

  • Place bag in a fruiting tent (an open plastic tarp enclosure or enclosed shelf with an open front)

  • Place a strip of plastic to loosely, yet, mostly cover the opening/ access. The fruiting process requires high humidity (75-90%), a bit of indirect light, and a bit of airflow

  • Humidity can be achieved by spraying the sides of the enclosure with clean (preferably filtered) water 2-3 times a day. Do NOT spray directly onto the bag or mushrooms as it could encourage contamination.

  • Bag could be placed in a pan of water filled with an inch or so of clean water to encourage humidity.

  • Change the water and clean the pan every few days or so to again, minimize contaminants

  • If all goes well, in a few days to a week or so, pins (primordia) should appear. That’s the baby mushrooms starting .... Finally!

  • When the caps flatten out it’s time to harvest.

  • About 4-7 days after pinning usually

Addendum: Step 1 instructions for pressure cooker (not recommended as is more hassle but it’ll work)

  • Soak straw in warm or hot water overnight or 8ish hours

  • Drain well in a screen or colander until damp but not dripping

  • Place drained straw in fruiting bag and wrap bag around bulk of substrate exterior like a loaf

  • Secure with a rubber band or two

  • Use a trivet in bottom of the pressure cooker and

  • perhaps some balls of crumpled aluminum foil to raise trivet 3-4” above bottom to keep bag above the water line

  • Add water to bottom of trivet

  • Place bag on trivet and place a plate or similar on top of bag to prevent bag from expanding and covering the steam release port

  • Pressure cook at 15psi for 90 minutes

  • Allow to cool and de-pressurize until cool

  • Open bag and place straw in a CLEAN/ alcohol wiped container

  • Go to step 2 and continue